The MCI InRows are compatible with external condensing units which are known as MCU. The InRows in this category are offered in different capacities. The compressors used in these products are BLDC type with variable speed drive control that are installed inside the condensing unit. In fact, BLDC compressors provide the InRow system with an additional control mechanism in order to accurately adapt the cooling load generated by the cooling system to the load imposed by the data center equipment. This reduces the response time to temperature adaptation. On the other hand, the electronic expansion valve and variable-speed fans of InRow system and condensing unit will contribute to accurate temperature adaptation.

:Technical specifications of condensing units

 In order to complete their cooling circuit, the above InRows need to be connected to the appropriate condensing unit according to the table below.

Note:

The device is fed through 3-phase 380 volt power to the condensing unit, and the condensing unit feeds the InRow interior unit through 220 volt single-phase power.

The most important characteristics of MCI inverters

1. The frame structure is made of ST37 oil sheet with high strength

2. Electrostatic powder paint on the InRow body with RAL 9005 code

3. Electrostatic powder paint on the condenser unit body with RAL 7035 code

4. Use of electric expansion valve

5. The ability to feed the device from two separate power sources and a switch between them (according to request)

6. The ability to separate each fan from the system separately, even when the system is working

7. High energy efficiency with variable speed fans of InRow Unit and Condensation Unit

8. Use of variable speed compressors with new BLDC technology to reduce energy consumption and more uniform performance and longer lifespan.

9. Connecting to the network through the Modbus TCP_IP and SNMP protocols and the ability to connect through BACnet protocols

10. The possibility of networking (Rotation) several InRow with each other up to 16 numbers

11. Functionality in 3 different control modes Supply only, Return only and Supply+Return

12. Equipped with a separate controller for the condensing unit apart from the controller of the InRow unit

13. Ability to install filter dirt warning sensor (optional)

14. Ability to install a drain pump in the pan (optional)

15. Ability to install a separate leak sensor (optional) apart from the pan float sensor

16. Equipped with a float sensor in the pan

17. No need to enter 3-phase electricity into the interior space of the data center aisels

18. Use of coil with Blue Fin technology for longer life

19. Installing the compressor in the condensation space of the outdoor unit to facilitate the repair and maintenance process

20. Functionality 24*7*365